General Information - Self Adhesive Wall Decorations
Material
All images are printed on self-adhesive, peel and stick polyester.
The stickers are designed for indoor use on any flat, clean, dry
surface.
Adhesive
The stickers are removable. Adhesive will not remain on the wall
when the stickers are removed.
Surfaces
Adheres to almost any smooth surface such as metal, wood, glass,
cardboard, paper, plastic etc.
Important
Do not place a sticker within reach of a young child's crib or bed
to avoid the possibility of the sticker falling into the infant's
possession without supervision. Avoid placing the stickers near
direct sources of heat.
Application Instructions
Only apply the sticker to a smooth, clean and dry surface. The sticker
may not adhere properly if applied to uneven or textured surfaces.
If the walls have been painted within 4 weeks please follow the
instructions for special surfaces below. Remove entire backing.
Be careful not to bend or kink the sticker. After backing is removed,
press exposed sticker to surface. Finish by softly rubbing the entire
sticker with a soft cloth, making sure to include all edges. On
the larger stickers it may be easier to peel and stick a top portion
first and then remove the remaining backing. Finish by rubbing with
a soft cloth. If, after completion, you are unhappy with the positioning,
simply remove and stick again. If the sticker does not stick well
or curls at the edges, follow the instructions below.
To apply to rough or glossy surfaces
The stickers work best on flat walls with clean, dry flat paint.
They will work on other surfaces with varying degrees of success.
When you get your order, if possible try a small sticker. If it
doesn't stick well, you can use an adhesive that does not melt or
dissolve Polystyrene such as 3M® Super77. To use a spray adhesive
lay some newspaper down and place the sticker face down on the newspaper.
Spray the adhesive on the back of the sticker and let it dry for
15 minutes (or as spray manufacturer instructs). The adhesive should
be dry when you put the sticker up or it will create a more permanent
bond. Be careful not to get glue on the face of the sticker. Very
glossy surfaces might require extra glue as well. For these cases
an adhesive such as 3M® Hi-Strength 90 can be used. We recommend
that this procedure be used in high traffic and commercial installations
such as nursery schools and paediatric centres. The use of a 3rd
party adhesive is not guaranteed in any way.
Removing stickers
The stickers can be simply peeled off. If you find a sticker pulls off the paint, you can release the sticker by squirting lighter fluid on the wall above the sticker. The lighter fluid will run down the wall and soften the adhesive. The lighter fluid will evaporate off the wall in a few minutes.
Once the sticker is off, lay it face down for a few minutes and let the lighter fluid evaporate. You can then re-apply the sticker.
Cleaning stickers
Use a cloth or paper towel moistened with water only and gently
blot. Do not soak, rub or use soap or abrasives.
Warranty & Returns
Please see our Terms and Conditions.
Shipping
We ship all over the world. See ordering information
for further information.
|